Chemical wood protective agent

        Wood door mainly refers to by physical, chemical and biological methods of wood preservative, flame retardant and carbonization change processing, to improve the performance and the quality of wood, the wood preservation technology is core of the wood door industry. SICONG Chemical wood  protective agent by spraying (coating) on the surface of the wood infiltrated into the wood internal, air permeable water repellent film forming a layer of visually imperceptible, prevent moisture intrusion, the wood moisture can still through the hydrophobic membrane barrier free dissemination of, to achieve both waterproof and breathable function, thereby maintaining wood appearance.

Product description:

        Good permeability, strong adhesion, can penetrate into the wood capillary hole, with a durable wear resistance, pressure and toughness, strong permeability. No film without light, keep wood natural characteristics and perception, giving wood preservative, waterproof, oil proof, antifouling properties, can effectively control the wood moisture content, prevent wood due to moisture and dry wet circulation caused by cracking, warping, distortion, black, rotten and moldy. Greatly improve the anti fouling performance of the wood surface, effectively prevent the daily colored materials such as: fruit juice, red wine, soy sauce, coke, tea, fine dust and oil (edible oil, oil) on the surface of the wood.

Scope of application:

Wooden floor, plywood, bamboo flooring, wall panels, wooden keel

Product characteristics:

Have：

An good permeability and strong adhesion.

The basic excellent water and oil repellency

An antifouling excellent

* specifications

The appearance of * micro yellow transparent solution

The density of * 0.95

* flash lower than 40 DEG C

The boiling point of * near 120 degrees C

The freezing point * namely the above 5 DEG C (reversible)

*.

Active solid content

(perfluoroalkyl acrylate polymer)

Organic solvent

Construction attention:

Surface treatment

       Construction surface drying, no dust, no pollution, no putty or paint coating, a the such as surface moldy, flooding phenomenon should first clean, long wet parts with blower and heater forced drying requirements.

Spraying construction

       The 818 wood protective agent with spray spray or brush besmear directly in the construction of the surface, each of the construction of the base surface should be continuously repeated spray brush twice, two road construction, the procedure interval for half an hour or so. Dry at room temperature for 3 to 6 hours with water repellent effect, a week after the effect is better.

Material

         A barrel can be sprayed (brush) coated with 20~40 square meters, the specific amount required is determined according to the material and surface condition of wood.

Matters needing attention：

(1) shall not be in the air humidity is too large (more than 90%) and the construction of 5 DEG in the environment

(2) coating construction, brush must use clean, absorbent strong soft brush, by the hair brush dipped in 818 wood door agent must be a one-time run out, can not be stored, within 24 hours after the construction does not

Can flush the construction surface, otherwise it will affect the effect, must re treatment. When the coating finishes, the protective agent must be completely dry before construction can be carried out.